Ⅰ. Product Parameters
|
Product Name |
Model NO. |
Rated Voltage |
Rated Frequency |
Rated Power |
|
Air Purifier |
KQJH006 |
100-220V~ |
50/60Hz |
50w |
Ⅱ. Product Display
- Rear Cover
- Air Quality Sensor
- Filter
- Air Outlet Grille
- Control Panel
- Machine Body
*Control Panel
Wind speed/ Filter reset
Power
UV/Anion/Light
Timing
Ⅲ. Operation Instructions
Before use, please remove the package of the filter.
Ensure the product is unplugged before removing or installing the filter.
- Installation:
- Press down the rear cover button inside the circle by hand, then lift the rear cover backward.
- Take out the filter from the product. Remove the packing of the filter.
- Put the filter into the product again.
- Press down the rear cover button inside the circle by hand.
- Insert the rear cover into the body forward.
- Buttons:
When the product is powered on, the machine will light on and off, then the indicator light will be on to indicate entering standby mode.
- Power on/ off:
Touch the power button to turn on/off the machine, the machine beeps once. The back light will display the relevant colors according to the PM2.5. (If you turn off and then turn on the product without pulling out the power plug, the machine will default to the working state before shutdown)
- Timing:
In the power-on state, the machine will beep every time you touch this button, and you can choose the timing time (2H/4H/8H/continuous).
- Wind Speed:
In the power-on state, the machine will beep every time you touch this button, and you can choose the wind speed (Auto-Low-High).
- UV/Anion/Light
In the power-on state, the machine will beep every time you touch this button, and you can choose the light mode (Standard-Soft-Off)；
Long press to turn on/off UV and Anion, and the corresponding indicator lights up (Note: When UV is turned on, it will run in automatic mode, on for 2 hours and off for 2 hours, and cycle like this)
Ⅳ. Cleaning and maintaining
- Replace the Filter
- Please clean the dust on the filter regularly. The filter cannot be washed or reused.
- Always turn off the machine and unplug it from the electrical outlet before replacing the filter.
- Do not use a vacuum cleaner to clean the filter.
- Please regularly put the filter in sunlight to sterilize.
Note: The continuous flashing red light of the filter symbol indicates that the filter needs to be replaced. Please use the original filter, do not use any other to replace. Press and hold the wind speed button for about 7 seconds to cancel the alarm reminder after replacing the new filter,
- Cleaning steps:
- Shut down and unplug the power plug;
- Take out the filter and clean the dust adsorbed on the outer surface of the filter;
- Clean the air inlet/outlet, and wipe the shell of the product with a neutral detergent and a soft cotton cloth;
- After the product is dry, install the filter into the air purifier, put on the rear cover and start using it.
Note: When wiping the air outlet, no water is allowed to enter the inside of the machine.
- Maintaining Instructions
- Ensure the product is off and unplugged before maintenance.
- Do not immerse the air purifier in water or any liquid.
- Do not use abrasive, corrosive, or flammable cleansers (such as bleach or alcohol) to clean any part of the unit.
- Do not wash the filter with water.
- Do not use a vacuum cleaner to clean the filter.
- Please place the purifier in a well-ventilated place out of direct sunlight.
- To ensure a good performance of the product, please turn on the product for a few minutes from time to time if it isn’t in use for a long time.
Ⅴ. Safety Precautions
- To avoid electric shock and fire, do not allow water, liquid, or any flammable detergent to get into or to clean the product.
- Do not spray any flammable material such as pesticides or perfumes around the product.
- Before connecting the power supply, please check whether the voltage of the product is consistent with the local power supply voltage.
- If the power cord is damaged, in order to avoid danger, it must be replaced by professional staff.
- Please stop using it if the plug, power cord, or product is damaged.
- Do not block the air inlet and outlet, and do not place anything on the air outlet or in front of the air inlet.
- Do not insert things into the machine.
- This product is not recommended to be used by people (including children) who have physical, sensory or mental impairments, or lack relevant experience and common sense, unless they are used under the supervision and guidance of guardians.
- Children are forbidden to play with the product.
- Do not allow children to clean and maintain the product without supervision.
- This product can not replace normal ventilation, daily dust collection, or oil pumping when cooking.
- Ensure the product socket is well connected to the plug. If not, the plug will be hot.
- Do not place any items above the product.
- Be sure to place and use the product on a firm, flat and horizontal surface.
- Leave at least 30cm of space on the back and sides (inlet) of the product, and at least 50cm of space above the product (outlet) when using.
- Do not place the product under an air conditioner to prevent condensation water from dropping into the product.
- Ensure both the filter and the back cover are properly installed before connecting power.
- Please use the filter specially designed for this product. Do not use any other non-original filters.
- Burning of the filter may cause irreversible harm to human or endanger other lives. Do not take the filter for fuel or similar purposes to avoid irreversible harm.
- Do not use hard objects to strike the products, especially the air outlet and air inlet.
- Do not insert a finger or other things into the air outlet/inlet to prevent physical damage or trouble.
- Do not use this product when you are using an indoor spray repellent, or in a place filled with grease, flammable gas, or chemical fumes.
- Ensure the product is unplugged before moving, cleaning, maintaining, and replacing the filter.
- Unplug the power connection before moving the product. Do not pull the wire to move the product.