Cart
/

ELECTRIC JUICER ZZJH009 USER MANUAL

SPECIFICATION

Product name

Model No.

Rated volume

Rated voltage

Rated frequency

Rated power

Appliance classes

ELECTRIC JUICER

PUE-2109N

0.18L

220-240V~

50/60Hz

200W

ClassII

 

ILLUSTRATION

  1. Juice cup  
  2. Pomace cup  
  3. Spiral auger  
  4. Pusher rod  
  5. Juice collection cup  
  6. Juice valve  
  7. Feed container lid  
  8. Hopper grinding component
  9. Main unit  
  10. Base  
  11. Switch

 

OPERATION

  • First use
    Remove the hopper grinding component, spiral auger, juice collection cup, and pusher rod. Clean them thoroughly with detergent, then air dry for later use. Wipe the exterior of the main unit with a damp cloth.
  • Operation
  1. Install the juice collection cup according to the indicated direction, then place the spiral auger into the cup, ensuring that the auger is fully fitted onto the main unit's shaft. 
    Note: The spiral auger must be properly placed onto the shaft and pressed down completely; otherwise, the other components cannot be installed correctly.

Align the juice outlet with the groove on the left side of the front of the main unit, and then lower it into position.

  1. Insert the hopper grinding componentinto the juice collection cup by pressing it downwards, and then rotate it to lock it into place. 
    Note: The feed container lid must be open during installation.

  2. Close the feed container lid and connect the power. 
    Note: The product will not function properly if the feed container lid is not securely closed.

  1. Cut the ingredients into 5x5 cm pieces for preparation.  

Note:  

① This juicer is not suitable for processing the following fruits:  

Fruits with high hardness or high fiber content, such as sugarcane.  

Sticky fruits like avocados, bananas, figs, mangoes, papayas, dragon fruits, bayberries, etc., as these can easily clog the filter.  

② You may use the pusher rod to assist in juicing by guiding the ingredients.

  1. Place the pomace cup and juice cup tightly against the machine, positioning them under the pomace outlet and juice outlet.

  1. Open the feed container lid, place the ingredients into the grinding component, close the lid, and turn the switch to the "Juicing" mode to start the machine.  

Note:  

① Before juicing, remove seeds and pits from the fruits and vegetables to avoid damaging the auger.  

② When juicing multiple types of produce, start with the softer varieties and then move on to the harder ones.  

③ Add the ingredients one at a time, at a moderate pace, and avoid overloading the hopper.  

④ The continuous working time should not exceed 10 minutes.

  1. Turn the switch to the "ON" to start the machine. If the juicer jams during operation, turn the switch to the "Reverse" mode to release the ingredients, then switch back to "ON" mode to continue. Once juicing is complete, turn the switch to the "Off" position.  

Note:  

  • If the ingredients become stuck, follow these steps:  
  1. Turn the switch to "Off" to stop the machine.  
  2. Turn the switch to "Reverse" to clear the jam.  
  3. Turn the switch back to "ON" to resume.  
  • During operation, do not switch directly from "ON" to "Reverse" mode; always stop briefly at "Off" before turning to "Reverse."
  1. Open the juice and pomace valves, using the juice cup to collect the juice and the pomace cup to collect the pomace.

 

CLEANING AND MAINTENANCE

  • Note:
  1. Before cleaning, ensure the power is disconnected and wait until the main unit has completely stopped running before disassembling and cleaning.
  2. Clean the product promptly after use and wipe it dry.
  3. The main unit can be wiped with a damp cloth. The feed container lid, hopper grinding component, spiral auger, juice collection cup, juice cup, pomace cup, and pusher rod can be rinsed directly with water.
  4. Do not use steel wool, abrasive cleaners, or corrosive liquids to clean the product. Ensure the product is clean and dry before storage.
  5. Store the product in a dry place, away from direct sunlight.
  • Disassembling and Cleaning the Juice Collection Cup
  1. Open the feed container lid. Turn the grinding component counterclockwise to remove it. If you encounter any resistance while turning, try rotating it clockwise fully before turning it counterclockwise again.

  1. Remove the juice collection cup assembly by lifting it upwards to take it out completely.

  1. Remove the auger shaft by pushing it out with your hand.

  1. Clean the pomace outlet of the juice container. First, turn the juice container upside down, then remove the silicone seal from the pomace outlet for cleaning. After cleaning, ensure that the silicone seal is properly reinstalled to prevent juice leakage during operation.

Remove the silicone seal from the waste outlet.

To reinstall the silicone seal, align it with the outlet and carefully press it back into place.

  1. To clean the silicone seal on the rotating shaft of the juice collection cup, first turn the cup upside down. Use your thumb to push out the shaft silicone seal, then rinse it with water. Once cleaned, press the seal back into place firmly.

Disassembly: Push downwards to remove.

Installation: Push upwards to reattach.

Note:

  1. Check the Groove: Ensure that the groove in the shaft silicone is fully inserted into the hole of the juice collection cup to prevent leakage.
  2. Orientation of the Silicone: After installation, the larger flat surface of the silicone should face inward, while the smaller surface should face outward.
  • Maintenance:
  1. If the product is not cleaned immediately after use, stainless steel components and other parts may corrode or discolor due to salt and residues from the ingredients. Contaminants can dry out, making the parts difficult to disassemble and clean, or affecting the performance.
  2. After using the product, ensure that all components are cleaned thoroughly and dried before storing them in a clean location.
  3.  For long-term storage, make sure to clean the product with a brush and store it properly.
  4.  Do not use boiling water or high-temperature cleaning agents, steel wool, abrasives, or sharp cleaning tools.
  5.  Do not place the components in a dishwasher or dryer.

 

CAUTION

  1.  Do not place the product too close to heat sources such as stoves to prevent damage, fire, or personal injury.
  2.  Do not allow children to operate the product unsupervised. Ensure that it is not used as a toy and keep it out of reach of infants. Elderly or disabled individuals, as well as those without experience, should use the product under supervision and guidance.
  3.  If the plug or any other part is damaged, stop using the product immediately and have it repaired or replaced by a qualified technician at an authorized service center to avoid injury.
  4.  Do not use the product on an inclined or unstable surface.
  5.  This product is for household use only and is not suitable for commercial purposes.
  6.  Do not operate the product without contents or overload it.
  7. Do not hang the power cord over sharp objects or connect it to movable objects.
  8.  If the power cord, plug, or other components are damaged, they must be replaced by the manufacturer, its service department, or similarly qualified personnel to avoid danger.
  9.  Do not move the product or touch moving parts while it is operating to avoid accidental injury.
  10.  Do not use fingers, spoons, or chopsticks to push ingredients into the feed opening.
  11.  Do not use accessories or attachments other than those provided with the product to avoid fire or personal injury.
  12.  Never operate the product unattended.
  13. Do not immerse the main unit in water or any other liquids to avoid damage.
  14. Avoid rapid and frequent switching between the "Juice" and "Reverse" modes to prevent fire risks.
  15.  Do not place parts in dishwashers, microwaves, sterilizers, or hot water above 60°C to prevent deformation or damage.
  16.  Ensure that the voltage matches the product specifications (220V~50Hz) to avoid safety hazards and damage. Maintain a distance of at least 30 cm from other kitchen appliances.
  17.  Ensure the product is turned off and unplugged before disassembling or adjusting any parts.
  18.  Maintain a safe distance from the power outlet and keep the plug within easy reach, away from flammable or explosive materials. Ensure proper grounding of the power outlet.
  19.  Turn off the power switch and disconnect the power before changing attachments or accessing moving parts.
  20.  Ensure the work surface is clean and free of grease before use.
  21.  Unplug the product after use and clean it promptly.
  22.  Do not use inferior extension cords to avoid fire risks.
  23.  Do not use the product if the filter is damaged.
  24.  This product is not suitable for processing hard foods such as grains, ice, sugarcane, or ginger, which may cause blockages or mechanical failures.
  25.  Do not use frozen or ice-cold foods in the product.
  26. Before starting, make sure all parts are correctly assembled to avoid accidents. Do not introduce hard objects, metal parts, wood, or ceramics into the blending area during operation.
  27.  Do not use the product continuously for more than 10 minutes. Allow at least 30 minutes of rest between continuous operations to prevent triggering the motor's overheating protection.
  28.  If you notice unusual sounds, odors, excessive heat, or smoke during use, turn off the power immediately and have the product serviced at an authorized repair center.
  29.  Clean all parts that come into contact with food after use to avoid odor from residue over time.
  30.  Carefully read the instruction manual before use to prevent misuse and adverse consequences.

 

TROUBLESHOOTING

Anomalies

Reasons

Methods

The machine stops working suddenly during operation

Overloading with too much fruit and vegetables causes blockage

Rotate the switch to the “Reverse” position to push out any excess food. If the machine still does not resume working after three attempts, please remove the clogged fruits and vegetables.

Fruits and vegetables do not be cut into small pieces

Cut the fruits and vegetables into small pieces before putting them in the machine

Machine malfunction

Consult customer service for after-sales repair.

The juice leaks out of the main unit

The silicone seal on the bottom shaft of the juice collection cup or the silicone seal on the waste outlet is not properly installed.

Reassembly

Abnormal sound

Parts are making a squeezing noise during juicing.

The machine might make a squeezing sound when operating, which is normal. Please use it with confidence.

Machine malfunction

Consult customer service for after-sales repair.

Feed container and juice collection cup can not be unscrewed

Excessive pomace in the juice collection cup

Switch the control to the “Reverse” setting to expel the residue. Hold the juice collection cup and gently twist it left and right a few times while lifting it upwards.

Check whether hard objects, such as cores, are stuck in the juice collection cup

Rotate the switch to the "Reverse" setting to push hard objects back into the feed opening.

Excessive pomace on the upper lid and in the juice collection cup

Add water to the top cover and juice collection cup, and let it sit overnight to soften any stuck fruit pomace.

Containers and accessories are tinged after use

Containers and accessories are easy to be colored because fruits and vegetables have coloring pigments in nature

It is normal. Please rest assured to use.