SPECIFICATIONS
|
Product Name |
Model No. |
Filter material |
Flow rate |
Working pressure |
Working temperature |
|
DRINKING WATER FILTRATION |
JSQH005 |
Activated carbon block |
2L/min ;0.5GPM |
15-100 psi |
41-122°F |
ILLUSTRATION
①Main Housing
②Purified Water Outlet
③Tap Connector Parts
④Tap Connector Ring
⑤Purified Water Switch
⑥Raw Water Outlet
①teflon tap
②wrench
③waterproof washer
④washable diatom filter : E-multifunctional connector; ABFG-internal thread; CD-external thread
ASSEMBLY
- Remove the original faucet adapter if there is an adapter in your faucet.Choose the right adapter to match your faucet threading.
- Installation method of threadless faucet
Loose the multifunctional connector with a screwdriver, and put it on the outlet of the threadless faucet. Then tighten the connector. Make sure it is tightly fixed to avoid water leakage.
Please check the connecting rings and make sure the washer is inside. Tighten the ring and the multifunctional connector, then turn on the faucet filtration system. Switch between two modes to check for leaks.
If there is no water leakage, turn on the faucet to rinse the purifier until it flows out clean and pure water.
- Installation method of internal thread faucet
Prepare required accessories and Remove the bubbler from the faucet.
Choose the suitable waterproof washer and thread connector. Install them into the faucet spout and use the wrench to tighten it.❗Remember to install the waterproof washer to avoid water leakage.
Check the waterproof washer. Tighten the faucet filtration system into the inner thread connector and turn it on. Switch between two modes to check for leaks. If there is no water leakage, turn on the faucet to rinse the purifier until it flows out clean and pure water.
- Installation method of external thread faucet
Prepare required accessories and remove the bubbler from the faucet.❗Remember to install the waterproof washer to avoid water leakage.
Choose the suitable waterproof washer and inner thread connector. Install them into the faucet spout and use the wrench to tighten them.❗Remember to install the waterproof washer to avoid water leakage.
Check the waterproof washer. Tighten the faucet filtration system into the inner thread connector and turn it on. Switch between two modes to check for leaks. If there is no water leakage, turn on the faucet to rinse the purifier until it flows out clean and pure water.
OPERATION
Purified water switch as shown on the left, filtered water will flow out. Purified water switch as shown on the right, and unfiltered water will flow out.
CAUTION
- Applicable water pressure for the purifier is 0.1-0.4Mpa. When using in high pressure areas, please reduce the water consumption.
- Applicable temperature is 41-122° F. Please do not use in hot water. If you accidentally passhot water through the purifier, the filtered water will temporarily smell bad.
- Please do not block the water outlet of the purifier or connect it with other equipment to avoid damage.
- Children must use under adult supervision to avoid accidental injury.
- Before each use, run water through the filter for 5 to 10 seconds to activate the filter. Flush the system for 1 minute before use after a long time of non-use.
- If you encounter any problems with use or installation, please feel free to contact our customer service.