Before using the smart humidifier for the first time, you should leave the humidifier at room temperature for half an hour before turning it on.
The applicable working environment of the humidifier is 5-40℃, and the relative humidity is less than 80%RH;
How to add water
Open the water tank cover and fill it with water. Then close the water tank cover.
Water should not exceed the highest water level
Turn the switch to the right to adjust the mist size.
When there is a shortage of water, the machine will automatically stop and the red light will turn on. The machine will resume normal operation after refilling the water.
When using the humidifier, please place the machine on a level table.
When filling the water tank, you need to remove the decorative cover of the water tank and use a water container to add water (do not add water to the mist outlet; do not lift the water tank when the machine is working). The water must not exceed the maximum water level.
After turning on the power, touch the power button to start or set the machine into standby mode.
Touch the mist volume button to adjust the mist volume to the desired level.
After working for about five minutes, the machine will enter the sleep and screen-off state.
Touch the constant humidity button to set the desired one. When the ambient humidity of the machine reaches the set, the machine enters standby mode and stops fogging; when the machine detects that the ambient humidity is lower than the set value, the machine will start again
Touch the timer button to set the shutdown time
Before lifting the water tank, please adjust the mist volume to the minimum or turn off the power to prevent splashing water from getting wet on your countertop.
Please use clean water below 40 ℃(purified water is recommended)
If the machine has not been used for a long time, the water tank should be cleaned before next use.
After the machine stops working, there is a small amount of water in the water tank, which is normal.
Ⅳ. Cleaning and Maintaining
Please turn off the machine and unplug the power cord before cleaning.
The scale and debris in the humidifier tank must be cleaned regularly. It is recommended to clean it once every 2-3 weeks.
You can use a clean clothes to wipe the exterior surface.
Turn off the machine and cut off the power supply.
Remove the water tank, add descaling agent to the sink and clean it with clean water.
Pour the mixed liquid out of the water tank after several times of shake, then add pure water into the water tank, pour it dry after shaking at last. Repeat the above several times until the sour smell in the machine is eliminated.
Ⅴ. Safety Precautions
Please use the correct power supply voltage 220V~50Hz.
Do not force boot the machine when there is no water in the water tank.
Please do not add any additives not produced or supervised by our company into the water tank.
It is prohibited to add water at the mist outlet.
It is prohibited to block the fog outlet. Please keep the top of the fog outlet unobstructed.
It is prohibited to store flammable and explosive items around the humidifier, and do not place it near a heat source.
This product is Y-wire connected. If the supply cord is damaged, it must be stopped at once and replaced by professionals from the manufacturer or its maintenance department to avoid accidents.
It is prohibited to directly shower the humidifier with water.
Do not place this machine near water sources.
Please use pure water with a water temperature below 40 ℃.
Never sit on this machine.
It is prohibited to turn off the humidifier by directly unplugging the power plug.
When filling and cleaning, you must first turn off the humidifier and unplug the power plug.