Shopping Cart

Portable Blender ZZJH004 User Manual English Version

Ⅰ. Specification parameters

Product name

Portable Blender

Input Voltage


Model No.


Battery capacity


Rated power


Charging voltage


Rated capacity


Charging current


Ⅱ. Parts name

  1. Lid
  2. Waterproof glue
  3. Lid Handle
  4. Bowl
  5. The blade
  6. Cup holder
  7. USB cable
  8. The battery
  9. The motor
  10. Circuit board
  11. Bottom cover non-slip apron
  12. The base
  13. USB waterproof circle

Ⅲ. Product instructions

  • Charge Description
  1. Connect the power supply, such as a computer charger and mobile phone charger, to the charging interface of the base of the juicer via a USB cable. At this time, the button indicator light is red and the product is in a charging state.
  2. When the button indicator is blue, the battery is fully charged. At this point, unplug the power terminal and USB cable to complete the charging.
  • Tips
  1. Battery charging time is 4-6 hours, depending on the season.
  2. Charge the battery at least once every three months. Otherwise, the original power will be used up and the battery life will be affected.
  3. It is necessary to charge and discharge lithium batteries frequently.
  • Operating Instructions

  1. Wipe the blade and blade base. Check that the sealing ring is installed correctly, install the sealing cup, and tighten it slightly.
  2. Wash the fruit, peel and seed it, cut it in a counterclockwise direction, clean it, and cut it into 10x10x10mm pieces.

  1. Please put the cut fruit into the juicer, add water, and screw on the lid clockwise.
  2. Then tilt the whole machine down about 45°and double-click the start button switch. The work indicator light is blue. The operating time of the product is 20-30 seconds per cycle.
  • Tips:
  1. The total amount of fruit/water should not exceed 300ML of the body's maximum water level (3/4 of the body), and the water temperature should not exceed 40°.
  2. Hard fruits and vegetables (such as carrots) should not exceed 50g.
  3. Please put the whole machine horizontally on your hand, tilt the juicer 15 degrees to shake back and forth, or unscrew the lid and pour the juice back and forth. Shake back and forth throughout the process for better juicing.
  4. After extracting the juice, drink straight from the cup or pour it out.
  • Tips: 
  1. Gently shake the product in the process of working, the stirring effect will be better.
  2. The main body is equipped with safety devices. If not tightened, the machine will not start.
  3. If the blender gets caught in a large piece of food during the juicing process, the machine will stop working and will only return to normal after cleaning.

Ⅳ. Maintenance

  • After use, it is recommended to clean the product immediately, so to avoid residual juice deterioration and odor. Please refer to the following operations when cleaning:
  • The whole machine cleaning
  1. Add blender to 1/2 cup water, add a little dishwashing liquid if necessary. Stir for about 30 seconds.
  • Clean the lid and cup
  1. Unscrew the lid and cup counterclockwise, open the lid, and rinse under the tap or in warm water with detergent. When cleaning, pay attention to whether the sealing ring of the cup cover and drinking hole is in the corresponding position of the lid after cleaning.
  • Host cleaning
  1. It is strictly prohibited to soak the host in water or rinse it with clean water! When wiping the host, use a wrung-out damp cloth to wipe it clean.
  2. The blade is sharp. It is recommended to clean the blade with a cleaning brush. Be careful of scratches!
  3. Put the cleaned machine and parts in a ventilated place to dry, and then assemble and collect. (4) Products and components are prohibited from sterilization in high-temperature cabinets. Do not soak the product in boiling water! Otherwise, the product will be seriously deformed or damaged!

Ⅴ. Safety precautions

  • In order to ensure safe use and avoid personal injury and property loss to you or others, please observe the following safety precautions:
  • Failure to comply with safety warnings and misuse may result in an accident.
  • Forbid
  1. No load or overload is allowed. The maximum juicing time of this product is 20-30 seconds after the product automatically stops working. If continue juicing, restart the key switch. It is recommended that this product should be used continuously for no more than 4 times. In the process of use, if the base is found to be overheating, the machine should be stopped for 30 minutes.
  2. When the product is working, it is forbidden to unscrew the lid and put the hand or other hard objects into the cup to prevent accidents. This product is a special fruit blender. It is forbidden to use it for mincing meat or grinding beans or other products, otherwise, the service life of the product will be affected.
  3. Do not put the parts of this product into the dishwasher, disinfection cabinet, microwave oven, and other cleaning equipment with a high temperature of over 60℃ to clean or disinfect, so as to avoid deformation of parts by heat.
  4. The fresh juice of this product should be drunk or stored in time. Do not store it in the cup for more than 6 hours, or the juice will easily deteriorate and be harmful to the human body.
  5. Do not use other than this product's accessories.
  6. Do not allow children, or people with intellectual disabilities to contact and use this product.
  • Attention
  1. This product drives the dc motor to work through the battery, and the battery can be charged by connecting with the external power supply.
  2. The product cup and blade holder must be tightened completely to avoid water leakage when the product is working. The food in the portable cup should not exceed the maximum scale of the portable cup.
  3. This product is equipped with an overheat protection device, in case of abnormal use or serious overload operation of the motor, this product will automatically stop, and the button indicator light up. If the blade is stuck during use, please release the switch immediately, remove the stuck ingredients on the blade, and continue to use it after the motor cools down.
  4. Due to the sharp blade, please be careful when disassembly and cleaning.
  5. After use, please turn off the main power switch.
  6. When the base (battery) is low, charge it in time.