Ⅰ. Specification
|
Product name |
Product Model |
Voltage |
Frequency |
Power |
|
STAND GARMENT STEAMER |
GTJH014 |
220V |
50Hz |
2000W |
Ⅱ. Components and installation drawings
- Hanger
- Nozzle hook
- Nozzle
- Three-section telescopic rod
- Steam Hose
- Aluminum rod adjustment buckle
- Plastic spring
- Switch knob
- Water tank
- Body
- Fuselage
- Ironing board
Ⅲ. Product Installation Instructions
- Preparation for use
- Insert the telescopic aluminum rod into the fixing hole of the main unit until it reaches the end.
- Unlock the lock button, pull up the telescopic aluminum rod, adjust it to the proper position, and press the lock button.
- Insert the steam hose into the host and screw it clockwise.
- Install the hanger on the nozzle hanger, and then install the hanger on the telescopic rod.
- Unscrew the water tank knob counterclockwise, pour clean cold water into the water tank, then tighten the water tank knob clockwise, and put the water tank on the host.
- Turn on the power, adjust the knob switch, and the switch light is on. Indicates that the machine is working normally. After 45 seconds, the steam hose nozzle sprays steam, and the clothes can be ironed
- Installation instructions for the ironing board
- Install the two clips of the ironing board into the slot.
- After adjusting the telescopic rod to the appropriate height of the table, insert the middle connecting rod on the back of the ironing board into the top of the telescopic rod, and lock the buckle, and the clothes can be ironed horizontally.
Ⅳ. Cleaning and maintenance
- Please turn off the power switch and unplug the power cord.
- Wait for the machine to cool down completely (at least 30 minutes).
- Take out the water tank, unscrew the knob of the water tank, pour out the water in the water tank, then wash it with clean water, and drain the water completely. Put the water storage tank back into the water storage tank.
- Reversely unscrew the main engine drainage (boiler cleaning) knob, drain the water in the main engine, and then tighten the drainage (boiler cleaning) knob.
- Put the machine in an open and dry place.
Ⅴ. Precautions
- Please use the correct power supply voltage of 220V~ 50Hz.
- Do not share the same circuit with other high-power electrical appliances.
- In order to prevent electric leakage and other dangers, please use the machine according to the purpose of this manual, and do not use it for other purposes.
- Do not immerse the machine, power cord, and plug in water.
- When the machine is working, be sure to take care of it to avoid accidents.
- Do not let children or the elderly use this product alone.
- Water must be filled before using the machine, please always pay attention to the water level when using it.
- Do not put the steam hose on the ground or bend it.
- Do not touch hot parts or steam when using to avoid burns.
- Please push the hanging rod to move the machine. In case of difficulty, do not move it forcefully. Please check the wheels after draining the water.
- Before storing the machine, please let the machine cool for at least 30 minutes and drain the water in the water tank.
- Before filling or draining water, please unplug the power supply first, and do not let the water splash out.
- Before cleaning, moving the machine, or when not in use, please turn off the power first and unplug it before proceeding.
- Do not place the machine near flammable items.
- When you find that the machine is faulty, the plug or the power cord is damaged, do not use the machine, let alone disassemble and replace it by yourself, you must immediately notify the customer service center.
- When pulling out the plug, you must hold the plug, and it is forbidden to pull out the plug by pulling the power cord.
- Do not use wire sockets to avoid fire hazards caused by excessive loads.
- Do not add cleaning agents to the water, otherwise, it will damage the machine. It is recommended to use distilled water.
- If the power supply cord is damaged, it must be replaced by the manufacturer, its service department, or similar professionals in order to avoid hazards.
- When using the appliance, pay attention to the danger of splashing due to steam.
- When filling and cleaning, the power plug should be unplugged.