Remove the protection film from the iron plate before first use.
Unplug the appliance and screw the temperature control (7) to position “0” (minimal).
Now connect the dry iron with a correctly installed power point.
Put the dry iron upright and select the desired temperature with the temperature control (7).
By doing so pay attention to the care symbols on the textiles: Chemical fibers/synthetic; Nature fibers/silk/wool; Nature fibers/cotton/linen
Assort your laundry to texture and corresponding iron temperature, iron the sensitive materials with the low temperature first as iron gets essentially faster hot than gets cold.
The pilot light (9) indicates that the iron gets hot. After the pilot light is off, the selected temperature has been reached and you can start ironing.
Ⅳ. Correct Disposal of this product
This marking indicates that this product should not be disposed of with other household wastes throughout the EU. To prevent possible harm to the environment or human health from uncontrolled waste disposal, recycle it responsibly to promote the sustainable reuse of material resources. To return your used device, please use the return and collection systems or contact the retailer where the product was purchased. They can take this product for environmentally safe recycling.
Ⅴ. Important Safeguards
Connect the dry iron with a correctly installed power point (220-240V). Make sure that the voltage of your dry iron is in accordance with the voltage of your power supply.
This appliance is not intended for use by persons(including children) with reduced physical, sensory, or mental capabilities, or lack of experience and knowledge unless they have been given supervision or instruction concerning the use of the appliance by a person responsible for their safety.
Children should be supervised to ensure that they do not play with the appliance.
Do not allow children to use it.
Unplug the appliance even during short-term absence.
The iron must not be left unattended while it is connected to the supply.
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent, or similarly qualified persons in order to avoid a hazard.
Do not use the dry iron if the appliance itself cable or the plug is damaged.
Do not immerse the dry iron in the water.
Keep the cable away from the hot iron plate.
Let the dry iron completely cool down storing it.
Always keep the instruction manual. In case the dry iron is given away to a third person instruction manual must be handed over, too.
Note: Before first use, test with an old tissue whether the iron plate is clean. Some parts have been lightly greased, thus smoke can rise during first use. This should stop after some moments.
The iron must be used and rested on a stable surface; when placing the iron on its stand, ensure that the surface on which the stand is placed is stable;
The iron is not to be used if it has been dropped, if there are visible signs of damage.
Q1: Why is it not hot?
A1: Please have a check on the light of it. If you have plugged it in and screwed the button, the light will be on. If it's not on, the product may be broken, please contact our customer service in time.
Q2: How long can it be used continuously?
A2: We recommend you to use it within 1-2 hours. Excessive use will shorten the service life of the iron.
Q3: Can it be added with water?
A3: No, it's totally a dry iron.
Q4: How about the pre-heated time?
A4: Dear, normally after about 20-30s later, it can be used to heat the clothes.
Q5: Why will it burnt my clothes?
A5: please don't put the iron on the clothes in the same place for a long time, like over 1-3 minutes, which will cause the clothes stuck on the iron surface, causing the broken piece of clothes.